Insulation

Insulating your home is one of the best ways decrease your energy costs. In the old days floors and walls were lined with just about anything to keep the moisture and cold air out of home. Renovations have revealed that even old newspapers were found packed into wall and floor boards.

Today insulating is a science all its own. There are R-factors assigned to different material and methods of insulating that give homes and buildings an appropriate amount of protection for their geographic region. The higher the R rating, the better insulated the home.

One of the top rated insulations is relatively new to the industry – probably no more than a couple of decades old – and it is called blow in insulation.

The Benefits of Blow In Insulation

There are several benefits to blow in insulation over rolls of fibreglass insulation. The benefits include the method of installing it, its energy efficiency and where it can be used. Here are the top 5 reasons to consider using blow in insulation:

1. Blow in insulation is fully adjustable. Depending on how much material winds up being used, it can create a protection with an R value of 15-38.

2. Only brand new materials are used to create most blow-in varieties of insulation. This means there is a reduced chance of allergies.

3. Blowing the material into the crevices allows for a tighter fit and seal. It can be directed around corners, beams, or wiring that may already be in the walls.

4. This type of insulation is extremely energy efficient. As it is blown in it expands and adheres to the surrounding surfaces. It fills even the tiniest of cracks as it does this.
 
The Complete Installation Process

After attaching the blanket to the surrounding boards, the small opening cut into it allows the hose to be pointed in all directions around the wall or ceiling. After the material is in place the blanket’s slit is closed and taped. This blanket does not act as a moisture barrier, it just control the spray. The material itself resists moisture.

Drywall or other wall materials are then installed right over the insulation blanket. In a renovation project this means that an entire wall would not have to be removed in order to insulation. Take an extremely old home for example. There may be no insulation at all. Instead of removing layers of plaster wall, you could simply make a hole, position the hose and fill the walls will energy efficient insulation. Then patch the wall and the job is complete.

The blow in insulation is more expensive than traditional insulation. However, experts estimate that energy savings is so great that within 2 to 4 years those costs are recovered.

This article was submitted to us by Flat Rate Construction.  Their website is located here:  http://www.flatrateconstruction.net.